OVER 50 YEARS★ LOCALLY OWNED ★SINCE1973
Eggers Electric service vans parked at the Loveland shop

Knob-and-tube wiring? Here's how we plan a safe rewire.

Knob-and-tube is the oldest wiring you'll find in homes, used from the late 1800s into the 1940s. It has no ground wire, its insulation gets brittle with age, and it was designed to shed heat into open air. That's why the electrical code doesn't allow it in hollow spaces where insulation surrounds it. Most homeowners replace it during a rewire, often room by room, before adding insulation, selling or remodeling.

Call 970-669-1883
“…they are remarkably responsive to questions and needs during a project.”
Google review · Fort Collins · Feb 2026 EV & inspections
Call 7 days, 7am–8pm

Schedule service or ask a question

Call 7 days, 7am–8pm
Same-day service is often available.

Why knob-and-tube needs attention

No ground

There's no equipment ground, so three-prong outlets on these circuits aren't grounded, and surge protectors can't do their job.

Brittle insulation

After decades of heat, the rubber and cloth insulation can crack or flake, especially where wires were handled.

Insulation around the wires

Knob-and-tube needs open air around it to cool. Blown-in insulation that buries it is not allowed by the electrical code.

Splices and add-ons

Decades of additions often tie new wiring into old circuits without boxes, and those splices are where problems start.

Too few circuits

These systems were built for a few lights and outlets, not today's kitchens, laundry and electronics. Overloaded circuits and overfused circuits are common.

Insurance and sale questions

Many insurers and buyers' inspectors ask about knob-and-tube. A plan to replace it, or proof that it's gone, helps.

Rewire, partial rewire, or leave it for now?

ApproachWhen it fitsWhat it involves
Full rewireMost or all circuits are still knob-and-tube, or you're insulating or remodelingNew circuits, boxes and grounds throughout, with wall openings kept as small as we can
Partial rewireOnly some circuits remain, or you're working one area at a timeReplace the remaining runs, starting with bedrooms, kitchen and the attic
Disconnect and abandonParts of the system are already bypassedConfirm old runs are dead and safely terminated
Leave it, for nowThe wiring is intact, untouched, in open air and not overloadedHave it checked, keep insulation off it, and plan replacement

How we handle a knob-and-tube rewire

  1. Eggers Safety InspectionA licensed electrician runs our 8-point check and traces which circuits are still knob-and-tube.
  2. Circuit mapWe find what's live, what's abandoned and where the splices are.
  3. Plan in writingYou get a written price for a full or phased rewire, room by room, with the order we'd do it in.
  4. Permit and rewireWe pull the permit, run new grounded circuits and boxes, and work from the attic and basement where we can to limit wall openings.
  5. Inspection and paperworkWe meet the inspector and give you an itemized invoice for your insurer or a buyer. The work is backed by our 1-year workmanship warranty.

What's included in every visit

On every visit, a licensed Eggers electrician handles the job you called about and runs our full Safety Inspection. There's a $89 service charge — and it is credited toward your job if you move forward.

The 8 points: electrical panel, main grounding & bonding, GFCI protection, smoke & CO detectors, outlets & switches, visible wiring, exterior electrical, and whole-home surge protection. Each one is marked Pass or Needs Attention.

Eggers Electric crew in front of company vans in Northern Colorado

Locally owned in Loveland since 1973. Your neighbors, not a national chain.

About Eggers Electric

Knob-and-tube questions

Questions? Call 970-669-1883 or email info@eggerselectric.com.

Why homeowners choose Eggers

  • Locally owned in Loveland since 1973
  • Licensed electricians
  • Permits pulled and inspections handled
  • Eggers Safety Inspection on every visit

Serving Loveland, Fort Collins and Northern Colorado · 970-669-1883

Is knob-and-tube wiring safe?

It wasn't built for today's loads, it has no ground, and its insulation gets brittle with age. Wiring that's intact and in open air may still work, but most homeowners replace it, and it should never be buried in insulation.

Can I add insulation over knob-and-tube wiring?

No. The electrical code doesn't allow knob-and-tube in hollow spaces where insulation surrounds the wires. Replace or retire the wiring first.

How do I know if I have knob-and-tube?

Look in the attic or unfinished basement for single wires on white ceramic knobs and through ceramic tubes in the framing. We can confirm which circuits are still live.

Can knob-and-tube be replaced without tearing out walls?

Often with limited openings. We fish new wire from the attic and basement where we can, and make small openings where we can't.

Will insurance cover a home with knob-and-tube?

Some insurers ask about it or won't write a policy until it's replaced. Proof of replacement, such as an itemized invoice and permit record, helps.

Do I need to rewire the whole house at once?

No. Many homes are rewired in phases, starting with the highest-risk areas. Our article Does my house need rewiring? covers the signs.

Schedule service onlinePick a day and time that works for you.
Loading available times…
Prefer to talk? Call 970-669-1883, 7 days a week, 7am–8pm.
Call 970-669-1883
Eggers Safety Inspection + diagnose/estimate — $89 service charge, credited toward your job. Schedule Service ›

Through Dec 17: donate food for the Larimer County Food Bank and we’ll waive the $89.

Google 4.9 · 400+ reviews

Need an electrician?

On every visit, a licensed Eggers electrician handles the job you called about and runs our full Safety Inspection. There's a $89 service charge — and it is credited toward your job if you move forward.

Through Dec 17: bring non-perishable food for the Larimer County Food Bank and we’ll waive the $89 service charge.

Schedule Service

Have a question? Ask us

or call 970-669-1883 · Call 7 days, 7am–8pm

Ask a question

How can we help?

Send us a message and we’ll follow up. Need help now? Call 970-669-1883.