
Knob-and-tube is the oldest wiring you'll find in homes, used from the late 1800s into the 1940s. It has no ground wire, its insulation gets brittle with age, and it was designed to shed heat into open air. That's why the electrical code doesn't allow it in hollow spaces where insulation surrounds it. Most homeowners replace it during a rewire, often room by room, before adding insulation, selling or remodeling.
“…they are remarkably responsive to questions and needs during a project.”
There's no equipment ground, so three-prong outlets on these circuits aren't grounded, and surge protectors can't do their job.
After decades of heat, the rubber and cloth insulation can crack or flake, especially where wires were handled.
Knob-and-tube needs open air around it to cool. Blown-in insulation that buries it is not allowed by the electrical code.
Decades of additions often tie new wiring into old circuits without boxes, and those splices are where problems start.
These systems were built for a few lights and outlets, not today's kitchens, laundry and electronics. Overloaded circuits and overfused circuits are common.
Many insurers and buyers' inspectors ask about knob-and-tube. A plan to replace it, or proof that it's gone, helps.
| Approach | When it fits | What it involves |
|---|---|---|
| Full rewire | Most or all circuits are still knob-and-tube, or you're insulating or remodeling | New circuits, boxes and grounds throughout, with wall openings kept as small as we can |
| Partial rewire | Only some circuits remain, or you're working one area at a time | Replace the remaining runs, starting with bedrooms, kitchen and the attic |
| Disconnect and abandon | Parts of the system are already bypassed | Confirm old runs are dead and safely terminated |
| Leave it, for now | The wiring is intact, untouched, in open air and not overloaded | Have it checked, keep insulation off it, and plan replacement |
On every visit, a licensed Eggers electrician handles the job you called about and runs our full Safety Inspection. There's a $89 service charge — and it is credited toward your job if you move forward.
The 8 points: electrical panel, main grounding & bonding, GFCI protection, smoke & CO detectors, outlets & switches, visible wiring, exterior electrical, and whole-home surge protection. Each one is marked Pass or Needs Attention.

Questions? Call 970-669-1883 or email info@eggerselectric.com.
Serving Loveland, Fort Collins and Northern Colorado · 970-669-1883
Written by the Eggers Electric team
It wasn't built for today's loads, it has no ground, and its insulation gets brittle with age. Wiring that's intact and in open air may still work, but most homeowners replace it, and it should never be buried in insulation.
No. The electrical code doesn't allow knob-and-tube in hollow spaces where insulation surrounds the wires. Replace or retire the wiring first.
Look in the attic or unfinished basement for single wires on white ceramic knobs and through ceramic tubes in the framing. We can confirm which circuits are still live.
Often with limited openings. We fish new wire from the attic and basement where we can, and make small openings where we can't.
Some insurers ask about it or won't write a policy until it's replaced. Proof of replacement, such as an itemized invoice and permit record, helps.
No. Many homes are rewired in phases, starting with the highest-risk areas. Our article Does my house need rewiring? covers the signs.
Through Dec 17: donate food for the Larimer County Food Bank and we’ll waive the $89.
★★★★★ Google 4.9 · 400+ reviews
Need an electrician?
On every visit, a licensed Eggers electrician handles the job you called about and runs our full Safety Inspection. There's a $89 service charge — and it is credited toward your job if you move forward.
Through Dec 17: bring non-perishable food for the Larimer County Food Bank and we’ll waive the $89 service charge.
Schedule Serviceor call 970-669-1883 · Call 7 days, 7am–8pm
Ask a question
Send us a message and we’ll follow up. Need help now? Call 970-669-1883.