
You may need to go from 100 to 200 amps if a load calculation shows your home can't safely carry what you run and plan to add, like an EV charger, heat pump, electric range or hot tub. Not every home does. Eggers Electric runs the numbers first, then handles the service upgrade, permit and utility work in Loveland, Fort Collins and Northern Colorado.
“…they are remarkably responsive to questions and needs during a project.”
One sign alone doesn't mean you need 200 amps. It means it's time for a load calculation.
A load calculation adds up your home's size, its fixed appliances, heating and cooling, and anything you plan to add, using the load calculation methods in the National Electrical Code (Article 220).
It gives you one of four answers:
| Part | Who owns it (usually) | Changed in a 100→200A upgrade? |
|---|---|---|
| Utility service drop or underground lateral | Utility | Sometimes; the utility decides |
| Meter | Utility | Utility sets or swaps it |
| Meter base (socket) | Homeowner | Usually, to one rated for the new service |
| Service mast or entrance conductors | Homeowner | Usually |
| Main panel and main breaker | Homeowner | Yes |
| Grounding and bonding | Homeowner | Brought up to current code |
| Surge protection | Homeowner | Added; required when service equipment is replaced |
Ownership details vary by utility. We confirm with yours before the job.
| Panel swap (same amps) | Service upgrade (more amps) | |
|---|---|---|
| Fixes | Unsafe, damaged or full panel | Not enough total capacity |
| Meter base | Usually stays | Usually replaced |
| Utility | Disconnect and reconnect | Review, possibly new service, disconnect and reconnect |
| Time and scheduling | Shorter | Longer; depends on utility scheduling |
On every visit, a licensed Eggers electrician handles the job you called about and runs our full Safety Inspection. There's a $89 service charge — and it is credited toward your job if you move forward.
The 8 points: electrical panel, main grounding & bonding, GFCI protection, smoke & CO detectors, outlets & switches, visible wiring, exterior electrical, and whole-home surge protection. Each one is marked Pass or Needs Attention.
The install itself typically takes one day, with the power off for about 4 to 8 hours. Jobs that need a new meter base, a panel move or underground service work can take longer or need a second day. Most of the calendar time is permit and utility scheduling, so the whole process from first visit to finished work typically takes a few weeks, depending on your city and utility. You get a timeline with your estimate, and we tell you ahead of time when the power will be off. See how long does a panel upgrade take?
You get a written price before any work starts.
“I called them early this morning, and within a couple of hours Chris was here to figure out why one circuit kept kicking the breaker. Turns out it was a floor outlet that had been cooking for a while. We had no clue.…”
“I requested quotes from four Northern Colorado electric companies, and Eggers provided the most competitive rate by a wide margin…”Google review · Fort Collins · Jun 2025 Repairs & troubleshooting
More capacity for EVs, heat pumps and remodels
Meter base and mast repairs
More circuits for garages, shops and basements
Replace old wiring and protect what you plug in
Home EV charger installation
Dedicated hot tub circuits
Standby units and transfer switches

Questions? Call 970-669-1883 or email info@eggerselectric.com.
Serving Loveland, Fort Collins and Northern Colorado · 970-669-1883
Written by the Eggers Electric team
Not every home does. Many homes with 100-amp service do fine. Homes adding an EV charger, heat pump, induction range or hot tub often need more. A load calculation tells you.
The install typically takes one day, with the power off for about 4 to 8 hours. Permit and utility scheduling add calendar time, so the whole process typically takes a few weeks. We give you a timeline with your estimate.
Yes, for part of install day, typically about 4 to 8 hours. We tell you ahead of time so you can plan.
Yes. The utility reviews the change and handles the disconnect, meter and reconnect. We coordinate it for you.
Often, yes. A load-management device or a lower charger setting can make it fit. See do I need a panel upgrade for an EV charger?
Rarely for a typical home. Very large homes, homes with several big electric loads, or a home plus shop can need more than 200 amps. The load calculation shows it.
No. A panel upgrade replaces the breaker panel. A service upgrade also raises the amperage coming in, which usually means a new meter base and service wires.
Through Dec 17: donate food for the Larimer County Food Bank and we’ll waive the $89.
★★★★★ Google 4.9 · 400+ reviews
Need an electrician?
On every visit, a licensed Eggers electrician handles the job you called about and runs our full Safety Inspection. There's a $89 service charge — and it is credited toward your job if you move forward.
Through Dec 17: bring non-perishable food for the Larimer County Food Bank and we’ll waive the $89 service charge.
Schedule Serviceor call 970-669-1883 · Call 7 days, 7am–8pm
Ask a question
Send us a message and we’ll follow up. Need help now? Call 970-669-1883.