OVER 50 YEARS★ LOCALLY OWNED ★SINCE1973
Eggers Electric service vans parked at the Loveland shop

Federal Pacific, Zinsco & Challenger panel replacement

Federal Pacific Stab-Lok and Zinsco are older panel brands with known safety concerns, and many electricians recommend replacing them. CPSC testing found many FPE breakers failed certain UL calibration tests. If your Loveland or Fort Collins home has one, Eggers Electric will check it, explain what we find, and give you a written price to replace it, with permits and utility work handled.

Call 970-669-1883
“…they are remarkably responsive to questions and needs during a project.”
Google review · Fort Collins · Feb 2026 EV & inspections
Call 7 days, 7am–8pm

Schedule service or ask a question

Call 7 days, 7am–8pm
Same-day service is often available.

Our promise

  • Upfront pricingYou approve the price before work starts.
  • On-time arrivalWe show up when we say we will.
  • Workmanship warranty1-year workmanship warranty on our work.
  • Licensed electriciansBonded, insured and local.

How to tell what panel you have

Look at the label on the panel door or inside the cover. Don't remove the cover; we'll do that.

BrandWhat to look for
Federal Pacific (FPE)"Federal Pacific Electric" or "FPE" on the label; "Stab-Lok" on the label or breakers
Zinsco / Sylvania-Zinsco"Zinsco" or "Sylvania" on the label
Challenger"Challenger" on the label
Other older panels we seePushmatic, and fuse boxes

Not sure? Take a photo of the label and the breakers (with the door open, cover on) and send it with your request, or we'll check on your visit.

What the concerns are

Federal Pacific Stab-Lok

In 1980 the company's parent reported to the U.S. Consumer Product Safety Commission (CPSC) that many FPE breakers didn't fully meet UL requirements, and CPSC testing confirmed certain calibration test failures. In 1983 the CPSC closed its investigation without deciding whether the breakers were safe, saying the data didn't establish a serious risk.

What that means for you: a breaker that doesn't trip during an overload or short can let wiring overheat.

Zinsco and Sylvania-Zinsco

Zinsco and Sylvania-Zinsco panels are another older brand that home inspectors and electricians commonly flag. They're no longer made, and correct replacement breakers can be hard to find. We check the panel and breakers for heat damage and tell you what we see.

Challenger

In 1988 Challenger recalled about 9,000 Type HAGF-15 and HAGF-20 GFCI breakers made in early 1988, because a part could stop the ground-fault protection from working. That recall covered those breakers, not Challenger panels. If you have a Challenger panel, we check which breakers are installed and evaluate the panel's condition.

Replace now or keep an eye on it?

We'll tell you plainly what we see. In general:

Replace soonPlan to replace
Signs of heat, scorching or melted partsPanel works, no damage, but it's an FPE or Zinsco
Breakers that won't reset, won't stay seated or trip randomlyYou're buying or selling, or your insurer has asked about it
Rust, water or burned busYou're adding an EV charger, heat pump or hot tub
No correct replacement breakers availableYou're remodeling and opening walls anyway

Why not just replace the breakers?

Correct replacement breakers for these older panels can be hard to find, and new breakers don't fix wear, heat damage or other problems in the panel itself. We'll tell you whether replacing breakers makes sense or a new panel is the better answer.

What a replacement includes

  • A new panel and breakers, sized by a load calculation
  • AFCI and GFCI protection where required
  • Whole-home surge protection, required when service equipment is replaced
  • Grounding and bonding brought up to current code
  • Every circuit labeled
  • Permit, inspection and utility coordination

If your service is also too small, we may suggest a 100 amp to 200 amp service upgrade at the same time.

How it works

  1. Your visit and Safety InspectionA licensed electrician checks the panel and runs the 8-point safety check.
  2. Plain-language findingsWe show you what we found, with photos if you want them.
  3. Written pricePanel replacement, and a service upgrade if it makes sense, each with a written price.
  4. Permit and utilityWe pull the permit and schedule with your utility.
  5. Install dayWe replace the panel, move circuits over and label everything.
  6. Inspection and walkthroughThe city or county inspects, and we walk you through the new panel. Backed by our 1-year workmanship warranty.

What's included in every visit

On every visit, a licensed Eggers electrician handles the job you called about and runs our full Safety Inspection. There's a $89 service charge — and it is credited toward your job if you move forward.

The 8 points: electrical panel, main grounding & bonding, GFCI protection, smoke & CO detectors, outlets & switches, visible wiring, exterior electrical, and whole-home surge protection. Each one is marked Pass or Needs Attention.

What affects the cost

  • Panel replacement only, or a service upgrade too
  • Number of circuits and the condition of the wiring
  • Whether AFCI or GFCI breakers are needed on the circuits we touch
  • Panel location and clearance
  • Permit and utility requirements for your address

You get a written price before any work starts.

What our neighbors say

400+ Google reviews
“I called them early this morning, and within a couple of hours Chris was here to figure out why one circuit kept kicking the breaker. Turns out it was a floor outlet that had been cooking for a while. We had no clue.…”
Google reviewRepairs & troubleshooting
  • “Andy came to our house to add an electrical outlet. While looking at possible solutions he was able to find us a solution that was half the price of the first solution he came up with…”
    Google review · Loveland · Dec 2025 Wiring, outlets & upgrades
  • “I requested quotes from four Northern Colorado electric companies, and Eggers provided the most competitive rate by a wide margin…”
    Google review · Fort Collins · Jun 2025 Repairs & troubleshooting
  • “We recently moved into a 100 year old house in the historic area of Loveland that had knob and tube wiring throughout…”
    Google review Wiring, outlets & upgrades
  • BBB Accredited Business, A+ rating
  • Eggers Electric Google reviews
  • 2024 Quality Business Awards winner
  • 2023 NoCo Style Readers’ Choice winner
  • Eggers Electric on Yelp
Eggers Electric crew in front of company vans in Northern Colorado

Locally owned in Loveland since 1973. Your neighbors, not a national chain.

About Eggers Electric

Federal Pacific & Zinsco questions

Questions? Call 970-669-1883 or email info@eggerselectric.com.

Why homeowners choose Eggers

  • Locally owned in Loveland since 1973
  • Licensed electricians
  • Permits pulled and inspections handled
  • Eggers Safety Inspection on every visit

Serving Loveland, Fort Collins and Northern Colorado · 970-669-1883

Is my Federal Pacific panel dangerous?

CPSC testing found that many FPE Stab-Lok breakers failed certain UL calibration tests, though the CPSC closed its investigation in 1983 without deciding whether they were safe. Many electricians, including ours, recommend replacing them. We'll check yours and tell you what we see.

Were Federal Pacific panels recalled?

No. The CPSC closed its FPE investigation in 1983 without a recall, and without deciding whether the breakers were safe. That's not the same as being cleared.

How do I know if I have a Zinsco panel?

Look for "Zinsco" or "Sylvania" on the panel label. Don't remove the cover; send us a photo or we'll check on your visit.

Can I just replace the breakers in my FPE or Zinsco panel?

Often it's not the best fix. Correct replacement breakers can be hard to find, and new breakers don't fix problems in the panel itself. We'll tell you which makes sense.

Will a home inspector flag my panel?

Often, yes. Many home inspectors note FPE and Zinsco panels and recommend an electrician evaluate them. We can check it and give you a written price.

Does my insurance care what panel I have?

Some insurers ask about older panel brands. Check with your insurer. We can tell you exactly what panel you have.

Do I need a permit to replace my panel?

Yes. Replacing a panel needs an electrical permit and an inspection from your city or county. We pull the permit and coordinate with your utility.

Schedule service onlinePick a day and time that works for you.
Loading available times…
Prefer to talk? Call 970-669-1883, 7 days a week, 7am–8pm.
Call 970-669-1883
Eggers Safety Inspection + diagnose/estimate — $89 service charge, credited toward your job. Schedule Service ›

Through Dec 17: donate food for the Larimer County Food Bank and we’ll waive the $89.

Google 4.9 · 400+ reviews

Need an electrician?

On every visit, a licensed Eggers electrician handles the job you called about and runs our full Safety Inspection. There's a $89 service charge — and it is credited toward your job if you move forward.

Through Dec 17: bring non-perishable food for the Larimer County Food Bank and we’ll waive the $89 service charge.

Schedule Service

Have a question? Ask us

or call 970-669-1883 · Call 7 days, 7am–8pm

Ask a question

How can we help?

Send us a message and we’ll follow up. Need help now? Call 970-669-1883.