
Big appliances like dryers, ranges, EV chargers, welders and air conditioners run on 240-volt circuits. Many other appliances, like microwaves, dishwashers, disposals, freezers and power-hungry shop tools, need their own 120-volt circuit so they don't trip the breaker. We match the circuit, breaker, wire and outlet to the appliance's nameplate, check panel capacity, add GFCI protection where required, and pull the permit.
“…they are remarkably responsive to questions and needs during a project.”
| Outlet | Typical use | Notes |
|---|---|---|
| NEMA 14-30 | Electric dryers | Four-wire, with a separate ground |
| NEMA 14-50 | Electric ranges, plug-in EV chargers, RVs | Four-wire; heavy, long-duration loads need a quality outlet |
| NEMA 6-50 | Welders, some shop equipment and EV chargers | Three-wire: two hots and a ground, no neutral |
| NEMA 6-20 / 6-30 | Air compressors, window or wall AC units, shop tools | Match to the equipment's plug |
| Hardwired | Water heaters, many EV chargers, mini-split condensers | No outlet; wired straight to the unit or disconnect |
Older three-prong dryer and range outlets (10-30 and 10-50) have no separate ground. When those circuits are replaced, they're updated to the four-wire style.
The installation manual says so. Microwaves, dishwashers, disposals and refrigerators often do.
A shared circuit can't carry the appliance plus everything else. See why breakers trip.
A new dryer or range with a four-prong cord on an old three-prong outlet. We update the outlet and circuit.
Compressors, welders, table saws and freezers in the garage often need their own circuit, and garage outlets need GFCI protection.
A range or laundry moving to a new spot needs a new circuit run.
Switching a gas range or dryer to electric. See heat pump and induction capacity.
On every visit, a licensed Eggers electrician handles the job you called about and runs our full Safety Inspection. There's a $89 service charge — and it is credited toward your job if you move forward.
The 8 points: electrical panel, main grounding & bonding, GFCI protection, smoke & CO detectors, outlets & switches, visible wiring, exterior electrical, and whole-home surge protection. Each one is marked Pass or Needs Attention.

Questions? Call 970-669-1883 or email info@eggerselectric.com.
Serving Loveland, Fort Collins and Northern Colorado · 970-669-1883
Written by the Eggers Electric team
Yes, if the panel has room and capacity. We match the outlet to your equipment's plug and add GFCI protection where the code requires it.
A 14-50 has two hots, a neutral and a ground; a 6-50 has two hots and a ground, with no neutral. Use the one your equipment's plug and manual call for.
Not by sharing the dryer's outlet. A plug-in EV charger needs its own circuit and a quality outlet. See EV charger installation.
In many locations, yes. Dwelling GFCI rules cover 125- to 250-volt outlets in garages, outdoors, basements, laundry areas and other listed spots.
New dryers and ranges are usually set up for four-wire outlets. Older three-prong outlets have no separate ground, so we update the outlet and circuit.
Yes. New circuits need an electrical permit and inspection in the towns and counties we serve. We pull it.
Through Dec 17: donate food for the Larimer County Food Bank and we’ll waive the $89.
★★★★★ Google 4.9 · 400+ reviews
Need an electrician?
On every visit, a licensed Eggers electrician handles the job you called about and runs our full Safety Inspection. There's a $89 service charge — and it is credited toward your job if you move forward.
Through Dec 17: bring non-perishable food for the Larimer County Food Bank and we’ll waive the $89 service charge.
Schedule Serviceor call 970-669-1883 · Call 7 days, 7am–8pm
Ask a question
Send us a message and we’ll follow up. Need help now? Call 970-669-1883.